FAZUA PEDELEC Notice Originale page 39

When the Battery Pack (1) is not within the charging temperature range, it will
not charge even when the Charger is connected. It will wait until the charging
temperature is reached before starting.
Charge-control indicator
When the Battery Pack (1) gets switched on, the start-up animation will be
shown on the charge-control indicator (3). After that, the LEDs will shortly show
the state-of-charge (3) of the Battery Pack (1).
Once the Battery Pack (1) is on, the state-of-charge can be checked by
briefly pressing the on/off button (2).
Each LED corresponds to 20% of the capacity. When charge is full, all five LEDs
light up. However, when the charge is empty, only the last LED will light up
intermittently. The state-of-charge of the Battery Pack (1) is also shown on the
Remote (see Remote Instructions).
Inserting/Removing the Battery Pack
Warning! Make sure both Battery Pack (1) and Drivepack (7) are
clean, otherwise, the friction created by the dirt may complicate
this operation.
To insert the Battery Pack (1) into the Drivepack (7), hold the Drivepack
(7) in one hand and Battery Pack (1) in the other hand. Make sure the
connector to the Drivepack (5) is facing the battery slot (8). Bring the
two together and gently let the Battery Pack (1) slip into the battery
slot (8) of the Drivepack (7) (Action A). Once the Battery Pack (1) is completely
inserted, the fastening lid (6) will automatically lock the Battery Pack (1).
To remove the Battery Pack (1) from the Drivepack (7), press down the
fastening lid (6) and, at the same time, pull the Battery Pack (1) out of the
battery slot (8) (Action B).
EN
37