FAZUA PEDELEC Notice Originale page 26

EN
Operation
Requirements
For running the eBike drive system, following requirements must be met:
• The Battery Pack is sufficiently charged, inserted and turned on (see
Battery Pack Instructions).
• Drivepack is mounted in the eBike.
• The speed sensor is properly connected to the Bottom Bracket and
spoke magnet justly placed (see Bottom Bracket Instructions).
Switching eBike System On/Off
To switch on the eBike press any of the Remote buttons (2,3,4). The Remote (1)
will shortly show the start-up animation and get into operation mode.
To switch off the eBike from the Remote (1) you have to press and hold the
middle button (3) of the Remote (1) for 2 s.
Other alternative options to switch off the eBike are:
Unmounting the Drivepack from the bike (see Drivepack Instructions).
•
Switching off the Battery Pack (see the Battery Pack Instructions).
•
Letting the eBike enter into inactivity (see Drivepack Instructions).
•
Note! Always switch off the eBike system when you park the eBike.
Display of the Remote
The display bar (5) on the Remote (1) consists of 11 LEDs.
The top LED is the notification indicator (7) meant for eBike status
•
notification.
The remaining 10 LEDs are meant for the state-of-charge and support
•
level bar (6).
24