FAZUA PEDELEC Notice Originale page 11

Locking/unlocking the drivepack within
your eBike
Once a Drivepack (1) is mounted in the eBike, it can be locked in so that the
Drivepack (1) cannot be removed. To lock a mounted Drivepack (1), insert
the key (10) into the lock cylinder (9) and turn it counter-clockwise (Action
C).
To unlock the Drivepack (1) from the eBike, insert the key (10) into the cylinder
(9) and turn it clockwise (Action D). In case of a lost key (10), a new key can
be ordered at keyservice.axasecurity.com. The key number can be obtained
using the Service Toolbox.
Charging the Battery Pack in your bike
Warning! Read carefully and respect the battery instructions.
Warning! Pay attention to your battery before each use and before
charging. Make sure terminals and surfaces are clean.
Warning! Before using or charging your Battery Pack, always look
for signs of damage like cracks or burns. Never use or charge a
damaged Battery. Please contact your FAZUA Service Partner or
visit the FAZUA Service Platform (www.fazua.com/service).
The Drivepack (1) can be mounted in the eBike, leaving the charging port of
the Battery Pack accessible to connect the charger. For that, dismount the
Drivepack (1) from the eBike (Action B). Push up the pressing chock (7) at
the lock (5) and the fastening hook (8) will come out (Action E, Step 1). Now
mount the Drivepack (1) back into the bike without pushing the upper part
all the way in (Action E, Step 2). This way, the fastening hook (8) fastens the
Drivepack (1) without being completely inserted.
Removing the USB cover
To use the USB connection (4) on the Drivepack, remove both screws on the
USB cover using a Torx 10 wrench. Use a plastic lever to lift off the USB cover.
The tightening torque for the screws is 0.5–1 Nm.
EN
9