State-of-charge and support level bar
The state-of-charge and support level bar (6) shows 2 parameters:
•
State-of-charge of your Battery Pack.
•
Selected support level of your eBike.
The state-of-charge of your Battery Pack is indicated by the number of LEDs
that are lit. Each LED represents 10% of the total capacity. When charge at
the Battery Pack is full, all 10 LEDs are lit. However, if Battery Pack is empty,
then no LEDs will light up.
The selected support level is represented with the color of the bar (6). There
are 4 possible colors this bar (6) can show and they refer to the 4 different
support levels.
Notification indicator
The notification indicator (7) will show notifications of errors or events in the
eBike in case they occur. If no errors are detected, the notification indicator
should not light up.
Different colors on the notification indicator (7) have different meanings :
•
Green: The notification indicator (7) briefly blinks green when the
Drivepack is mounted in the eBike. This provides visual feedback that
the system is ready to be switched on.
•
Yellow: The notification indicator (7) lights up yellow if a "Soft Fault" is
detected. This means that temporary or minor flaws are present and,
probably, a limitation in performance. Riding your eBike under a "Soft
Fault" is possible but not recommended.
•
Red: The notification indicator (7) lights up red if a "Hard Fault"
is detected. The eBike system will not work under a "Hard Fault"
condition and your eBike will need Service.
Note! The most common cause for a "Soft Fault" in your eBike is
the missing information from the Speed Sensor (see the Bottom
Bracket Assembly instructions).
In case of a permanent "Soft Fault", try reassembling the speed sensor magnet
(See Bottom Bracket Instructions). If this problem persists contact your FAZUA
Service Partner or visit the FAZUA Service Platform (www.fazua.com/service).
In case of a permanent "Hard Fault", contact your FAZUA Service Partner or
visit the FAZUA Service Platform (www.fazua.com/service).
EN
25