FAZUA PEDELEC Notice Originale page 20

EN
Assembly
Speed Sensor adjustment
The speed sensor (2) and the spoke magnet (4) must meet 2 conditions:
The position of the spoke magnet (4) at the spoke must let the magnet (4)
•
run past the magnet position mark (3).
The distance between the speed sensor (2) and the spoke magnet (4)
•
when facing each other must be in a 4-15 mm range.
Note! When the distance between speed sensor (2) and spoke
magnet (4) is not right, or if the speed sensor (2) is not properly
connected, the ebike will run under a "Soft Fault" condition notified
on the Remote (see Remote Instructions). If this happens, loosen
the screw of the spoke magnet (4) and fasten it again ensuring
that it runs past the mark of the speed sensor (3) maintaining
the right distance. If the problem does not get solved, contact
an authorized bicycle dealer or visit the FAZUA Service Platform
(www.fazua.com/service)
18