Intended Use; Basic Safety Instructions - Burkert 6650 Manuel D'utilisation

3.

INTENDED USE

Incorrect use of the flipper solenoid valves type 6650
can be dangerous to people, nearby equipment and
the environment.
• The device is a media-separated solenoid valve and
has been designed for use in conjunction with gases
and fluids (see Bürkert Chemical Resistance Chart:
www.burkert.com).
• Do not use the device outdoors without appropriate
protective measures.
• Use according to the permitted data, operating condi-
tions and conditions of use specified in the contract
documents and operating instructions.
• The device is not intended for operation without suit-
able power reduction electronics and must be oper-
ated only within the framework of the intended duty
cycle.
• Transport, store, install, operate and maintain the
device correctly as described in the operating
instructions.
• Use the device only as intended.
3.1. Restrictions
If exporting the system/device, observe any existing
restrictions.
english
4
• The connection clamps between coil and fluid housing
must not be removed under any circumstances.
• Do not make any internal or external changes to the
device.
• Do not put any loads on the housing (e.g. by placing
objects on it or standing on it).
• Installation and repair work may be carried out by
authorised technicians only.
• Ensure that the system cannot be activated
unintentionally.
• After an interruption in the power supply or pneu-
matic supply, ensure that the process is restarted in a
defined or controlled manner.
• The device may be operated only when in perfect
condition and in consideration of the operating
instructions.
• The general rules of technology apply to application
planning and operation of the device.
english
6
4. BASIC SAFETY
INSTRUCTIONS
These safety instructions do not make allowance for any
• contingencies and events which may arise during the
installation, operation and maintenance of the devices.
• local safety regulations; the operator is responsible for
observing these regulations, also with reference to the
installation personnel.
Danger – high pressure!
• Before loosening the lines and valves, turn off the
pressure and vent the lines.
Risk of burns/risk of fire if used continuously through
hot device surface!
• Keep the device away from highly flammable sub-
stances and media and do not touch with bare hands.
• Do not exceed the max. permitted duty cycle (see chap-
ter "6.1. Operating Conditions")
• Do not obstruct the heat dissipation that is required for
the operation.
General hazardous situations.
• The flipper solenoid valve type 6650 is not to be used
in areas where there is a risk of explosion.
NOTE!
Electrostatic sensitive components / modules!
The power reduction electronics, which is available as an
accessory, contains electronic components which react
sensitively to electrostatic discharge (ESD). Contact with
electrostatically charged persons or objects is hazardous
to these components. In the worst case scenario, they
will be destroyed immediately or will fail after start-up.
• Observe the requirements in accordance with EN
61340-5-1 and 5-2 to minimize or avoid the possibility
of damage caused by a sudden electrostatic discharge!
• Do not touch live electronic components!
Type 6650
english
5 5
english
7 7