CYBEX Solution B2-Fix + Lux Mode D'emploi page 9

RECLINING HEADREST
The Reclining Headrest (c) helps to prevent the child's head from dangerously
tipping forward during sleep. It can be set to one of 2 positions. Push the
Reclining Headrest (c) forward until the desired position is reached.
The child's head should always be in contact with the Reclining Headrest.
��
ADJUSTING THE HEADREST
The headrest (c) can be adjusted by using the headrest height adjuster (d) at
the back of the headrest (c). Adjust the headrest (c) so that max. 2 cm (approx.
2 finger's width) remain between the child's shoulder and the headrest (c).
The height of the headrest can still be adjusted while the seat is installed
��
in the car.
SECURING THE CHILD
1. Route the vehicle seat belt around your child and insert the belt tongue into
the belt buckle. It must lock into place with an audible "CLICK".
2. Place the lap belt in the red coloured lap belt guides (f) of the child seat.
3. Pull the shoulder belt to tighten the lap belt.
4. On the side of the car seat next to the belt buckle, the shoulder belt and the
lap belt must be inserted together in the lap belt guide (f).
5. Feed the shoulder belt through the shoulder belt guide (g) until it is inside
the belt guide.
6. Ensure that the shoulder belt runs across your child's clavicle and does not
touch your child's neck. If necessary, adjust the height of the headrest (c) to
change the position of the belt.
REMOVING AND REATTACHING THE SEAT COVER
The cover of the child seat consists of 4 parts (headrest (x2), backrest and
booster). These are held in position at several places by press-studs. Once all
studs have been released, the single parts of the cover can be removed.
In order to put the covers back on the seat, follow the removal instructions in
the reverse order.
The cover may only be washed at 30 °C with a delicate wash program
��
otherwise it may result in discolouration of the cover fabric. Please wash
the cover separately from other laundry and do not dry in the dryer or in
direct sunlight!
MANUFACTURER'S WARRANTY AND DISPOSAL REGULATIONS
CYBEX GmbH (Riedingerstr. 18, 95448 Bayreuth, Germany) gives you
3 years warranty on this product. The warranty is valid in the country, where
this product was initially sold by a retailer to a customer. The contents of the
warranty and all essential information required for the assertion of the warranty
can be found on our homepage
go.cybex-online.com/manufacturer-warranty-car-seats. If a warranty is
shown in the article description, your legal rights against us for defects remain
unaffected.
Please observe the waste disposal regulations in your country.
EN
7