Prepare The; Install The - Broan BDF Serie Mode D'emploi

3. PREPARE THE HOOD (
3.3 H
ORIZONTAL DISCHARGE ONLY
1. Remove the large shutoff plate 5 retaining screws located on the BACK of the hood.
Discard the shutoff plate and its screws.
2. Remove the small shutoff plate 10 retaining screws located INSIDE the back of the
hood. Set the screws aside and discard the shutoff plate.
3. Using the 10 screws previously removed in step 2, install the adapter in the inside
back of the hood.
4. Install the damper in the adapter, as shown beside.
4. INSTALL THE HOOD
Run power cable to installation location. Place the hood close to its location and insert
the cable in the hood.
Place the hood under the cabinet and tighten the wire clamp to secure the cable.
Make sure the adapter/damper assembly enters the ducting and the damper opens
freely. Secure the hood by installing and tightening the 4 no. ST4.8 x 15 mm mounting
screws (included) completely at sides locations (A).
' )
CONT D
HO0049
HO0048
HJ0005
A
-6-
HJ0002
A
HD0402