Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. PREPARE THE HOOD
3.1 A
LL INSTALLATIONS
1. Lay the hood on its top on a table. Use a
piece of cardboard to avoid damaging the
table or the hood. Slide the main grease
cup out and set aside. Remove the bottom
panel 7 retaining screws. Set bottom panel
and screws aside.
2. Remove both electrical box cover retaining screws. Remove cover and set aside with
screws. Turn the hood over and punch out the wiring knock-out located on TOP of the
unit and install the wire clamp (included).
3.2 V
ERTICAL DISCHARGE ONLY
1. Remove the shutoff plate 10 retaining screws. Set the screws aside and discard the
shutoff plate.
6"
ROUND DUCT INSTALLATION
2. Mount the 6" round adapter/damper on top of the hood, using the 10 screws
previously removed.
3¼"
10"
X
DUCT INSTALLATION
2. Mount the 3
1
⁄
" x 10" adapter/damper on top of the hood, using the 10 screws
4
previously removed.
G
C
REASE
UP
HO0173
-5-
S
L
CREW
OCATIONS
HO0046
S
L
CREW
OCATIONS
HO0047
HO0051
HJ0001
HJ0003
Publicité
Chapitres
Table des Matières
