Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. CLEANING AND MAINTENANCE (
S
:
TAINLESS STEEL CLEANING
Do:
• Regularly wash surfaces with clean cloth or rag soaked with
warm water and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe completely dry.
• You may also use a specialized household stainless steel
cleaner.
Avoid when choosing a detergent:
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never
be used close to a range.
E
:
NAMEL FINISH
Clean with warm water and mild detergent only. If discoloration occurs, use a good enamel polish such as automotive polish. DO NOT
use rough abrasive cleaner or porcelain cleaner.
8. OPERATION
Always turn on the hood before beginning cooking in order to establish an air flow in the kitchen. Let the blower run for a few minutes to
clear the air after turning off the range.
The hood is operated using the push buttons located on its front panel.
HC0050
1) Lighting push button
2) Delay push button
1. LIGHTING: Press the lighting push button (1) once to turn the lights on, press once more to turn them off.
NOTE: When lights are on, press the ON/OFF push button (4) twice to turn them off (the blower will start after the first push, but will
stop after the second). If blower and lights are on, press the ON/OFF push button (4) only once to turn lights and blower off.
2. DELAY: To set delay, press the push button (2) when blower is in use. The delay can be set from 1 to 9 minutes. Press the push
button (2) to increase time (adds 1 minute per push). Countdown will be displayed on the LCD screen and blower symbol will be
activated. Blower will continue to operate for the programmed minutes and then will stop automatically (delay setting mode does not
affect lighting as it works independently). To cancel delay function, press any other push button (1, 3 or 4) or follow the loop sequence
until it reaches 0. To turn delay function and blower OFF at once, press ON/OFF push button (4).
NOTE: When is use, delay mode will be canceled if blower speed is modified.
3. BLOWER: The blower push button (3) turns the blower on to three speed settings: LOW, MEDIUM or HIGH. Press the blower (3) or
ON/OFF (4) push button once to turn the blower on at the last selected speed (blower symbol will be activated). To change the blower
speed, press the blower push button (3) until the desired speed is obtained. Press the ON/OFF push button (4) to turn the blower off. The
last speed used will be memorized.
'
)
CONT
D
1
2
Don't:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction or renovation, cover the hood to make
sure no dust adheres to stainless steel surface.
3
3) Blower push button
4) ON/OFF push button
-10-
4
Publicité
Chapitres
Table des Matières
