Publicité
Les langues disponibles
Les langues disponibles
Install lateral ejection canal
1. Unlock the lateral impact protec-
tion (15) by pulling the locking
element (15a) to the left and
opening the lateral impact pro-
tection (15).
2. Mount the lateral ejection chan-
nel (24) and remove the lateral
impact protection (15). It holds
the side ejection channel (24) in
position.
Installing the Starter Cord
1. Pull the safety catch (3) towards
the handle bar (1) and hold it.
2. Slowly pull the starter cord on
the starter handle (22) towards
the bar and hook the starter
cord into the starter cord guide
(21).
3. Release the safety catch (3).
Filling with Engine Oil and
Checking the Oil Level
Place the equipment on a level
base.
1. Unscrew the oil filler cap and dipstick
(
7) and pour oil into the tank. The
oil tank holds 600 ml oil. Use brand oil
(e.g. SAE 30).
2. To check the oil level, wipe the dipstick
on a clean cloth and replace it in the
tank until it stops.
3. After pulling it out, read off the
oil level on the dipstick. The oil
level should be in the marked
area between the minimum and
maximum marks.
4. Wipe off any spilt oil and close
the oil filler cap (
7).
Check the oil level every time be-
fore mowing and add oil when the
lower marking point is reached.
Filling with Petrol
Warning! Petrol is flammable
and hazardous to health:
- Keep petrol in containers in-
tended for this purpose;
- Only refuel outdoors and never
with the engine running or when
the machine is hot;
- Open the filler cap carefully to
allow excess pressure to es-
cape;
- Do not smoke whilst refuelling;
- Avoid skin contact and inhala-
tion of the fumes;
- Remove spilt petrol;
- Keep petrol away from sparks,
open flames and other ignition
sources;
- Do not use petrol/oil mixtures;
- Use normal or super unleaded
petrol;
- Only use clean, fresh petrol;
- Do not store petrol for longer
than one month, as its quality
deteriorates
1. Unscrew the filler cap (
in the petrol to the lower edge of the
filler.
Do not fill the tank entirely, to allow the
petrol room to expand.
2. Wipe away petrol residues around the
filler cap and close the filler cap.
Setting the Cutting Height
The equipment has 6 positions for setting
the cutting heigh (25-75 mm):
GB
8) and pour
87
Publicité
