Publicité
Les langues disponibles
Les langues disponibles
GB
area especially. Do not use hard or
pointed objects, which could damage
the equipment.
•
Oil the wheels from time to time.
•
Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that all
nuts bolts and screws are sitting firmly.
•
Check covers and guards for damage
and that they are sitting correctly. Re-
place if necessary.
Replacing the Air Filter
Do not operate the equipment
without the air filter otherwise dust
and dirt will get into the engine and
result in damage to the machine
1. Release the screw at the air fil-
ter cover (14) and flip open the
cover
2. Remove air filter (13).
3. Replace a defective air filter
with a new filter (see "Spare
Parts").
4. To install, place new air filter
(13) into the air filter cover (14)
5. Close the air filter cover and
fasten screw again.
Change / adjust spark plug
A worn spark plug or a spark gap
that is too large will result in a re-
duction of engine performance.
1. Disconnect the spark plug con-
nector ((
plug by simultaneously pulling
and turning.
2. Unscrew spark plug (30) coun-
ter clockwise with a spark plug
socket.
90
11) from the spark
3. Check the spark gap using a
feeler gauge (available from
specialist shops). The spark gap
must be at least 0.75 mm.
4. If necessary, adjust the gap by
carefully bending the ground
electrode on the spark plug.
5. Clean the spark plug with a wire
brush.
6. Insert the cleaned and adjusted
spark plug or replace a dam-
aged spark plug with a new one
(Torch F6RTC or Champion
RN9Y or NGK BPR 6ES) (rec-
ommended torque 20 Nm, de-
termined with a torque wrench).
Changing the Engine Oil
Change the engine oil with the
petrol tank empty and the engine
warm.
• Change the engine oil for the
first time after around 5 operat-
ing hours then every 50 operat-
ing hours or annually.
• Dispose of the used oil in an
ecofriendly manner (see "dis-
posal / environmental protec-
tion").
1. Remove the spark plug connector
(
11).
2. Open the oil tank cover (
pump out the motor oil with an oil
pump.
3. Refill with engine oil (see "Initial Op-
eration").
Adjusting the Bowden Cable
If the Bowden cable becomes misplaced
for the drive and has too much play, it can
be adjusted.
7) and
Publicité
