Publicité
Les langues disponibles
Les langues disponibles
GB
Installing the Handle Bar
Caution! When installing
the handle bar, ensure that
the Bowden cables are not
squashed.
1. Fasten the lower handle bar (4)
using the bar fastening screws
and wing nuts.
You can determine the desired
tilt by selecting one of the pos-
sible screw positions.
2. Unfold upper handlebar (1)
and push locking lever (20)
D
toward bar.
3. Fix the Bowden cables to the
bar using the cable clamp (5)
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket (19):
1. Pull plastic loops (26) over bas-
ket rods (25).
Fixing the Grass Collection
Box onto the Equipment:
2. Lift up shock protection (6).
3. Hook the grass collection box
(19) into the mounting provided
for this (27) on the rear of the
equipment.
4. Release the impact protection
(6). It holds the grass collection
box in position.
86
Dismantling/Empty out the
Grass Collection Box:
5. Lift the impact protection (6) and
remove the grass collection box
(19).
6. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.
Level gauge
The level gauge (
the side of the grass catcher (
aerodynamic air guidance provided by the
flap also optimises the filling.
GO
Flap open: grass catcher empty
STOP Flap closed: grass catcher full
Mulch kit
Prior to using the mulch kit, the
lateral ejection canal has to be re-
moved (see
Attaching mulch kit
1. Remove the collection box
(
19), if used.
2. Lift the impact protection (6).
3. Push in the mulch kit (23). The
bracket (23a) snaps into place.
Remove mulch kit
4. Lift the impact protection (6).
5. Push in the bracket (23a) and
remove the mulch kit (23).
Lateral grass ejection
Before using the lateral grass
ejection, the mulch kit (
has to be inserted and the grass
collection box (
removed.
19a) is located on
19). The
).
23)
19) has to be
Publicité
