Kospel POC.D-5 Mode D'emploi page 16

Venting
1. Take the plug out of the socket.
2. Open the hot water tap and wait until it flows from a tap.
3. Set the temperature regulation knob at desired position.
4. Put the plug into a socket.
Temperature control
16
On the front part of the heater casing there is
a knob intended for temperature setting.
The knob set as on the figure (anticlockwise)
indicates the ‚switch off' position. Water
temperature setting should be chosen smoothly
from „ " (~7
When the diode (indicating ‚heating') is on, it
means water is being heated.
If the appliance is mounted in a place where
temperature drops below 0
empty the heater out of water:
­
­
POC5
Safety valve must regularly opened in order to
remove deposit and ensure it is not blocked.
POC10
C) position to „○○○
0
over­the­sink version (POC.G) ­ dismount
connecting tube from the inlet fitting (cold
water); open the hot water tap,
under­the­sink version (POC.D) ­ unscrew
flexible connectors (hoses) from the inlet
and outlet fittings (hot and cold water),
remove the heater from the wall (hooks)
and turn it 180 round.
0
○○○"or „III"(~70
0
C, you should totally
0
C).