Kospel POC.D-5 Mode D'emploi page 15

Hydraulic connection
POC.G and POC.D as a pressure appliances are designed to work on the system with
water pressure not exceeding 0,6MPa. If the water pressure in the system exceeds
0,6MPa, a pressure reducing valve has to be fitted before the safety valve on the cold
water supply pipe. An occasional leak may appear from the safety valve ­ it does not
mean that there is a fault; it is a normal state of the appliance. You must not block the
pipe as it might cause a malfunction. Safety valve as well as the outlet pipe can not be
installed in a room with temperatures below zero. Between the heater and the safety
valve no cut­off valve can be placed.
The POC.G heater must be mounted
with connections to down
POC.G
Electrical connection
The heater can be supplied with alternating voltage of 230V~. A cord with a plug
should be connected to a plug­in socket with a safety pin. Electrical system should fulfil
IEC­60364 standards.
Important! Do not connect the heater to the electric mains before the inner tank is
completely filled up with the water.
PL;DE;EN;FR-029B_f.1196
The POC.D heater must be mounted
with connections to the top
POC.D
[3] - inlet fitting
(cold water)
[4] - outlet fitting
(hot water)
[5] - hot water outlet
[6] - safety valve
[7] - pressure reducing
valve (if the water
pressure in the system
exceeds 0,6 MPa)
[8] - cut-off valve
[9] - cold water inlet
EN
15