Kospel POC.D-5 Mode D'emploi page 14

Installation/ Assembly work
14
1. Mount the heater on the wall in vertical position
according to two options given below:
a) fix two (stretching) pins ø 8 into the wall with
a 140 mm­distance between them,
­ screw the fixing screws in such a way that there
will be no more than a 4 mm­slot between a wall
and a screw head,
­ hang the heater on the fixed screws,
b) fix the special hanger to the wall and hang the
heater. In case of assembly of the POC.G with
additional battery set. POC.Gb, a spacing between
axes of fixing pins and the tap has to be kept.
2. According to figure bring the supply water to the
point where the heater is to be mounted. In the
heater:
a) POC.G or POC.D connect cold water to the inlet
fitting according to figure on page 20 and hot
water outlet to the outlet fitting. On the cold water
inlet supply pipe a mandatory safety valve [6] has
to be installed with a rated pressure of 0,6 MPa.
b) POC.Gb connect the heater to the tap (with
metal tubes or flexible connectors (hoses) ­
placing gaskets on the nuts beforehand. The
recommended distance between the axis of the
tube and the wall is ~34mm.
3. The discharge pipe, connected to the safety
device against excessive pressure should be
installed in an environment that is free from frost,
and should be directed to down.
4. After connecting the heater to hydraulic system,
open the hot water tap (red colour) and wait until
the inner tank is filled with water (when water
starts running from the tap).
5. Check connections for their tightness.