Briggs & Stratton SNAPPER 7800979-00 Manuel D'utilisation page 14

14
WARNING
Unsafe Operation Hazard
Grass Catcher bags are made of woven fabric, and are
subject to deterioration and wear during normal usage.
Check condition of bag before each use. Immediately
replace worn or damaged catcher bags with only genuine
replacement bags. The grass catcher is optional equipment
on some models.
Charging the Battery
(Optional Accessory on Some Models)
The battery provided with your mower is sealed and
maintenance-free. It requires no special care other than
keeping it properly charged. Use only the charger provided
with your mower when charging the battery.
Charge the battery after each use, and if the battery has been
stored for longer than 30 days. The time required to charge
the battery varies, but typically 16 to 24 hours will be sufficient
to bring the battery to a fully charged condition.
1. Remove the dust cap from the charger jack (A, Figure
15).
2. Plug the battery charger (B) into the charger jack.
3. Plug the charger into a 120-volt wall outlet.
4. Charge the battery for a period of 16 to 24 hours. (Longer
periods will not damage the battery.)
5. Unplug the charger from the wall outlet.
6. Unplug the charger from the charger jack.
7. Replace the dust cap onto the charger jack.
14
15
WARNING
Explosion Hazard
Avoid Serious Injury and Property Damage.
• DO NOT attempt to charge this battery with automotive
or 'Boost' chargers.
• DO NOT attempt to jump start a mower that has a dead
battery.
• Always use the charger supplied with this mower to
charge this battery.
Maintenance
Emissions Control Service
Maintenance, replacement, or repair of the emissions
control devices and systems may be performed by
any off-road engine repair establishment or individual.
However, to obtain "no charge" emissions control service, the
work must be performed by a factory authorized dealer. See
the Emissions Control Statements.
www.snapper.com