Publicité
Les langues disponibles
Les langues disponibles
Features and Controls
Note: The figures and illustrations in this manual are provided
for reference only and may differ from your specific model.
Contact your dealer if you have questions.
Compare Figure 2 with the table following.
2
A
Mulching Cover
B
Rear Height Adjustment Latch (2)
C
Oil Fill Cap and Dipstick
D
Rope Start Handle
E
Engine Speed Control
F
Drive Control
G
Blade Control
H
Ground Speed Control
I
Fuel Filler Cap
J
Front Height Adjustment Latch (2)
Operation
Before Starting
1. Check the guards, deflectors, grass bag, and covers to
make sure all are in place and securely tightened.
2. Check the blade control (A, Figure 3), drive control (B),
and ground speed control (C) to insure they work freely.
8
3
3. Check the cutting height. Adjust to the desired height.
See Cutting Height Adjustment .
4. Check the engine oil:
• Make sure the mower is on a level surface.
• Clean the oil fill area of any debris.
• Remove the dipstick (A, Figure 4) and wipe with a
clean cloth.
• Insert and tighten the dipstick.
• Remove the dipstick and check the oil level. It should
be at the top of the full indicator (B) on the dipstick.
• If low, add oil slowly into the engine oil fill. See Oil
Recommendations . Do not overfill. After adding oil,
wait one minute and recheck the oil level.
• Replace and tighten the dipstick.
4
5. Add fuel to the tank:
• Make sure the mower is outside, where fumes can
safely dissipate.
• Remove the fuel fill cap (C, Figure 4).
www.snapper.com
Publicité
