Dismounting; Disposal; Materials; Consumables - Abicor Binzel MF1 Mode D'emploi

11 Dismounting

11 Dismounting
Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power supply.
• Cut off the gas supply.
• Cut off the compressed air supply.
• Switch off the entire welding system.
• Pull the mains plug.
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-14.
1 Disconnect the cable assembly from the wire feeder.
2 Remove parts to be disconnected.
3 Dismount the MF1 frontdrive from the fastener on the torch.

12 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. Observe the regulations on the disposal of electronic scrap and dispose of it at your local waste
disposal site (e.g. recycling centre).
To correctly dispose of the product, it must first be disassembled. Please take note of the following
information:
 11 Dismounting on page EN-18

12.1 Materials

This product is mainly made of metallic materials which can be molten in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are marked in preparation for sorting and separation
of the materials for later recycling.

12.2 Consumables

Oils, greases and cleaning agents must not contaminate the ground and not enter sewage systems. These
materials must be stored, transported and disposed of in suitable containers. Please observe the relevant
local regulations and disposal instructions of the safety data sheets given by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with
the information provided by the manufacturer of the consumables.

12.3 Packaging

ABICOR BINZEL has reduced the packaging for shipping to a minimum.Packaging materials are always
selected with regard to their possible recycling ability.
EN - 18
DANGER
MF1