Proxxon GG 12 Manuel page 7

f) Dress properly. Do not wear loose
clothing or jewellery. Keep your hair,
clothing and gloves away from moving
parts.
Loose clothes, jewellery or long hair can
be caught in moving parts.
g) If devices are provided for the
connection of dust extraction and
collection facilities, ensure these are
connected and properly used.
Use of these devices can reduce dust
related hazards.
h) Only allow trained personnel to use the
power tool.
Apprentices may only operate the power
tool when they are aged over 16, when
this is necessary for their training and
when they are supervised by a trained
operative.
4.) Power tool use and care
a) Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it
was designed.
b) Do not use the power tool if the switch
does not turn it on and off correctly.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
c) Disconnect the plug from the power
source before making any adjustments,
changing accessories, or storing power
tools.
Such preventive safety measures reduce
the risk of starting the power tool
accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools carefully. Check
for misalignment or binding of moving
parts, breakage or damage of parts and
any other condition that may affect the
power tools operation. If damaged,
have the power tool repaired by a
qualified expert before use.
Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g) Secure the workpiece.
Use clamps or a vice to hold the
workpiece. This is safer than holding it
with your hand, and also it frees both
hands to operate the equipment.
5.) Service
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
Description of the machine
Engraving glass, acrylic and ceramic (and
also steel) is an enjoyable hobby.
Congratulations on purchasing the appro-
priate tool for this hobby. This is a precision
tool that will make this pastime a particular
pleasure. You will be satisfied with the
result of your work after just a little
practice.
Scope of delivery
1 engraving tool GG 12
1 ball-shaped abrasive diamond pencil
1.8 mm
Please note:
The GG 12 should only be used with
PROXXON power supplies.
- 7 -