Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
System Diagram/Mounting Brackets for Winch & SRL
Mounting the DH-AP-11
1.
Assemble both bolts through the offset bracket (DH-AP-10) and the
1-1/4" Tube section of the DH-AB Miller. Do not use the DH-AB-Miller
Spacer (see 1a) (DH-AP-11 consists of models DH-AP-10 and DH-AB-
Miller - available separately if required)
2.
After Assembling washer & nuts to both bolts, tighten nuts using a 9/16"
socket and 7/32" hex wrench to a snug fit (approx. 20ft-lbs.) (see 2a)
Mounting the DH-AP-11
1.
Assemble both bolts through the offset bracket and the 1-1/4" Tube
section and spacer as shown. (see 1b)
2.
After Assembling washer & nuts to both bolts, tighten nuts using a 9/16"
socket and 7/32" hex wrench to a snug fit (approx. 20ft-lbs.) (see 2b)
NOTE: MightEvac self-retracting lifeline should always be mounted to bottom
of Davit Arm Assembly and the ManHandler winch should always be mounted
to the top of the Davit Arm Assembly when used together or separately.
DH-AP-11
Winch/SRL Mounting Options for Use
1.
ManHandler (top) MightEvac (bottom) - Fall arrest and rescue
2.
ManHandler (top) Falcon SRL (bottom) - Fall arrest and rescue
3.
ManHandler (top) - Only for material handling, not for fall arrest
4.
MightEvac (bottom) - Only for fall arrest and rescue, not for
material handling
1
Us er Instru cti o ns - E ng l i sh
(for ManHandler winch - no spacer required)
1b
Spacer
(required)
2b
Davit Head
Assembly
U-Bracket
DH-AP-11 (no spacer)
Head Pin Assembly
Cable Assembly
3/8" Pin
Assembly
Davit Arm
Receiver Tube
WARNING
The DH-AP-11 brackets must offset MightEvac
and ManHandler. Handles must make a full rota-
tion, without interference.
11
11
11
1a
No spacer
required
2a
Tie Off
Carabiner
Anchor Ring
14" Extension
Post
Davit Anchor
Eye
Mounting
Anchor
Brackets
Rings
DH-AP-1
Upper
Section
Clamp
Screw
Knobs
Davit Arm
Sleeve
DH-AP-1
Mid Section
PFA Post
Publicité
Chapitres
Table des Matières
