Disposal And Recycling; Troubleshooting - Scheppach CSE2700 Traduction Des Instructions D'origine

• Machine data - type plate

13. Disposal and recycling

The equipment is supplied in packaging to preven it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE).

14. Troubleshooting

Fault Possible cause
Motor does not run No electricity
Chain brake
Running out of carbon brush
Chain does not move Chain brake
Poor cutting perfor- Blunt chain
mance Chain tension
Check that the chain is fitted correctly
Saw works only with Chain tension
difficulty Chain jumps
off sword
Chain becomes hot Chain lubrication
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
This product must be disposed of at a designated
collection point. This can occur, for example, by
handing it in at an authorised collecting point for the
recycling of waste electrical and electronic equip-
ment. Improper handling of waste equipment may
have negative consequences for the environment
and human health due to potentially hazardous sub-
stances that are often contained in electrical and
electronic equipment. By properly disposing of this
product, you are also contributing to the effective
use of natural resources. You can obtain information
on collection points for waste equipment from your
municipal administration, public waste disposal au-
thority, an authorised body for the disposal of waste
electrical and electronic equipment or your waste
disposal company.
Remedy
Check socket, cable and plug.
Damaged cable: Have repaired by Customer Ser-
vice. It is prohibited to patch the cable with insulating
tape. Damaged switches have to be replaced by a
Customer Service workshop
See section "chain brake" and "Releasing the chain
brake"
Change the carbon brush, ask a Customer Service
workshop
Check the chain brake, release if necessary.
Sharpen the chain
Chain wrongly fitted
Check the chain tension
Check the chain tension
Check oil level
Check Chain lubrication
GB | 35