Optika Italy B-1000 Serie Manuel D'utilisation page 12

10. Insert the power supply jack in the socket placed
in the rear side of the frame. (Fig. 9)
11. Open the lamp housing using the door lock screw
① and remove the lamp holder. (Fig. 10)
12. Remove the plastic block ② from the lamp holder
(or the exhausted one in case of replacement) by
loosening the two locking screws ③. (Fig. 11)
13. Insert the mercury bulb ④ (respect the polarity of
the bulb), tighten the locking screws and refit the
lamp holder inside the lamp housing. (Fig. 12)
Page 12
Fig. 9
①
Fig. 10
③
②
③
Fig. 11
④
Fig. 12