Publicité
Les langues disponibles
Les langues disponibles
4.2- Content
The unit package contains:
- Power unit
- Blade
- Blade scabbard
- Accessories (screwdriver, hex key, sparkplug wrench, flat wrench)
4.3- Assembly
WARNING - The blade has very sharp edges, always use protective gloves for safety.
Inspect the entire unit for loose fasteners and fuel leakage.
Make sure that the cutting attachment is properly installed and securely fastened.
4.4- Fuel
WARNING!
1. Gasoline is highly flammable.
Avoid smoking or bringing any flame or sparks near fuel storage or refuel area.
2. Make sure to stop the engine and allow it cool before refueling the unit.
3. Select outdoor bare and open ground for fueling and move at least 3 m (10 ft)
away from the fueling point before starting the engine.
4. Use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle
engine use
4.4.1- Recommended Mixing Ratio
Gasoline 40 : Oil 1
1. This engine is intended to operate on unleaded gasoline.
2. Make sure to use gasoline with a minimum octane number of 89RON
3. If you use a gasoline of a lower octane value than prescribed, there is a danger that the engine
temperature may rise and an engine problem such as piston seizing may consequently occur.
4. Poor quality gasoline or oils may damage sealing rings, fuel lines or fuel tank of the engine.
4.4.2- How to mix fuel
WARNING - Pay attention to agitation.
1. Measure out the quantities of gasoline and oil to be mixed.
Only mix the amount of fuel you need for the job you intend to do.
2. Put some of the gasoline into a clean, approved fuel container.
3. Pour in all of the oil and agitate well.
4. Pour in the rest of gasoline and agitate again for at least one minute.
As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary
for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger
of early piston seizing due to abnormally lean mixture.
5. Store fuel in a clean, approved container according to local regulations.
6. Put a clear indication on the outside of the container to avoid mixing up with gasoline or other
containers.
7. Indicate the contents on outside of container for easy identification
4.4.3- Fueling the unit
Note: Ensure that cap and its surroundings are clean. If not, clean as necessary.
1. Untwist and remove the fuel cap.
Rest the cap on a dustless place.
2. Put fuel into the fuel tank to 80% of the full capacity.
Never fill in tank to its full capacity.
Page 23 of 43
Publicité
