Ghibli & Wirbel POWER Serie Utilisation Et Entretien page 18

Checking and cleaning the motor
protection filter
- Remove the cylinder head as previously
indicated.
- Remove the filter (46 Fig. 30)
- Wash the filter (46 Fig. 30) with warm
running water removing all foreign par-
ticles and reassemble only after a thor-
ough drying.
- Insert the filter (46 Fig. 30) on the motor
hood then through the straps (47 Fig. 30)
hooking the elastic part on the top of the
filter with washers (48 Fig. 30).
- Reassemble in reverse order.
PROBLEM
The vacuum cleaner does
not work.
Suction is not satisfactory.
Checking the floater
- Remove the top as shown above.
- Remove the filter (46 Fig. 30).
- Check If the floater (45) is In good condi-
tion and if it moves freely in its space.
- Replace the filter (46 Fig. 30) as de-
scribed in the relevant section.
CAUSE
Switch not pressed.
Plug not inserted.
No current.
Paper bag full.
Filter elements clogged.
Accessories or
clogged.
Suction nozzle squeegee
worn or damaged.
ENGLISH - 4
Professional Cleaning Machines Since 1968
SOLUTION
Press the switch.
Insert the plug into the sock-
et.
Check the power supply line.
Replace the dust bag.
Clean the filter elements.
tubes Check and clean the flexible
hose and the suction nozzle.
Check and
squeegee.
www.ghibliwirbel.com
replace the