Ghibli & Wirbel POWER Serie Utilisation Et Entretien page 17

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
CLEANING AND
MAINTENANCE
DANGER:
Before performing any maintenance
operation, unplug the appliance from the
electrical socket.
Removing and replacing the paper
dust collection bag (if present)
- Release the levers (8 Fig.3) and remove
the cover (9 Fig.4) complete with motor.
- Remove the polyester filter (10 Fig.5).
- Remove the paper bag for collecting dust
(11 Fig.5), and replace it as described
above.
- Reassemble all the parts by following the
dismantling process steps in the reverse
order.
Emptying the recovery tank
- Release the lever (8 Fig.3) and remove
the top (9 Fig.4) along with the engine.
- Place it on the top of a drain and empty
the liquid in the recovery tank (35 Fig.18).
- Clean the inside of the tank with running
water and then re-install everything doing
the opposite of the disassembly.
For machines equipped with drain hose
- Release the exhaust tube (36 Fig.19)
from its base.
- Unscrew the button (37 Fig.20), re-
move the cap (38 Fig.20) of the ex-
haust hose (36 Fig.21) and drain the
liquid in the recovery tank (35 Fig.21)
For devices with rocking tank
- Release the lever (8 Fig.3) and re-
move the top (9 Fig.4) along with the
engine.
- Remove the tank locking device by
acting the lever (39 Fig.22) if any
- Lift the tank (35 Fig.23) with the ap-
propriate lever (40 Fig.23) until com-
pletely emptied.
- Replace everything doing the oppo-
site of the disassembly.
Daily cleaning
Checking and cleaning the polyester
filter (if present)
- Release the levers (8 Fig.3) and remove
the cover (9 Fig.4) complete with motor.
- Remove the polyester (4 Fig.5) filter.
- Clean the filter (Fig.24) from the inside
out with a blast of air; the filter can be
washed (Fig.24) in warm water and must
only be replaced once it is completely
dry. If it is too dirty, replace it.
- Reassemble all the parts by following the
dismantling process steps in the reverse
order.
Cleaning the appliance
- Clean the unit body with a cloth damp-
ened with water or a mild detergent.
- Remove the top, as described above and
clean the inside with running water and
then empty it, as indicated above.
Replace everything doing the opposite of
the disassembly.
DANGER:
Do not wash the appliance using jets of
water.
Periodic checks
Checking the air outlet filter
- Loosen the screws (41 Fig.25) and re-
move the cover (42 Fig.25).
- Remove the foam tank (43 Fig.26) and
the texture sponges (44 Fig.27) if any.
- Clean the sponges with a blast of air
(Fig.28).
The filter sponges can be washed in
warm water and must only be replaced
once they are completely dry; if too dirty,
replace them with new ones.
- Reassemble all the parts by following the
dismantling process steps in the reverse
order.
ENGLISH - 3