Operation; Letting In Air; Letting Air Out; Cleaning And Care - Crivit HG07914A Instructions D'utilisation Et Consignes De Sécurité

Operation

Note: Before using the product for the first time,
check it carefully for holes, porous places and or
seams that are not airtight by adult.
Recommendation: Blow up the product and
leave it alone for one day. Air new products in the
open air for a few days.

Letting in air

CAUTION! Inflatable plastic products react sensi-
tively to the cold and hot. That is why you should
never use the product when the ambient temperature
falls to below 15 ° C and rises above 40 ° C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible
for pumping the product up. Make sure that you do
not pump too much air into the product. On no ac-
count should you use a compressor. Stop the process
when resistance increases during pumping and the
seams start to stretch. Otherwise the material might
tear. Only use manual pumps and / or pumps specifi-
cally designed for use with inflatable plastic products.
IMPORTANT! Keep in mind that air temperature
and weather conditions can affect the air pressure
inside inflatable products. In cold weather the prod-
uct behaves as if it has less air pressure in it because
the air inside contracts. Under these conditions you
may have to add air. In hot weather the air inside
expands. Under these conditions you may have to
remove air in order to avoid overfilling.
Roll the product out first and then check for
holes, tears and other damage.
Open the valve
2
until the item is taut enough. Close the valve cap
and press the valve
light pressure for each chamber.
Make sure that the chambers are equally filled
with air one after the other.
10 GB/IE/NI
. Inflate all the air chambers
down by applying a
2

Letting air out

Pull the valve out and press the valve stem
2
lightly so that the air can escape or insert the
deflation tube into the valve
4
the air to escape quickly.
Note: Make sure that the product is com-
pletely dry before folding it together. This will
prevent the formation mould, bad odours and
discoloration.

Cleaning and care

Use a slightly damp, lint-free cloth to clean the
product.
On no account should you use corrosive or
scouring detergents.

Storage instruction

Make sure that the product is completely dry
both inside and out when wishing to store it for
any length of time. Otherwise mildew and
mould may form.
Store the product in dark, dry place – out of
reach of children.
The ideal storage temperature is 10‒20 °C.
Ensure that the product does not come into
contact with sharp objects during storage.

Repairing the product

Note: Minor damage can be repaired by the
owner using the supplied repair kit. Have any major
damage carried out at a specialist repair shop.
First let all the air escape from of the product
(see "Letting air out").
Cut the repair patch
hole.
Note: Ensure that the repair patch
larger than the hole and overlaps the edges
of the hole.
to allow
2
to suit the size of the
3
is
3