KTM 63512929544 Mode D'emploi page 31

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Insert the key and check whether the tumblers with the num-
ber 1 are correct.
Info
The tumblers must close flush with the locking cylin-
der.
Replace the non-matching tumblers with ones that have the
matching number.
500411-01
Info
The number of visible grooves indicates which tumb-
ler must be used. In this example, three tumblers with
the number 1 have been installed. Two grooves are visi-
ble on the two protruding tumblers. This means that
tumblers with the number 3 need to be installed. It is
recommended that you note the numbers of the mat-
ching tumblers so that the subsequent locking cylinders
can be equipped immediately.
Repeat the steps for chambers
six chambers are fitted with the correct tumblers.
500412-01
Insert spring
bn
plate
(all included) into chamber
Insert the key.
All tumblers must close flush with the locking cylinder.
Info
Chambers
500413-01
Mount O-ring
Position and insert the locking cylinder as shown in the figure
(the catch must point downwards).
Engaging plate
500414-01
B
D
,
, and
bo
for the engaging plate and insert engaging
I
.
G
H
and
are not used.
bp
(included).
bn
engages.
INSTALLATION 5
F
until the first
11

Publicité

Table des Matières
loading

Table des Matières