Specification; Dimensions And Connections - Stiebel Eltron DCE-S 6/8 Plus Utilisation Et Installation

iNSTallaTiON

Specification

15.2.1 Cleaning the strainer, standard installation on finished
walls
f Isolate the appliance from the power supply.
f Close the shut-off valve in the cold water inlet line.
f Open all draw-off valves.
f Remove the cold water threaded fitting.
f Remove the strainer from the twin nipple using a flat-blade
screwdriver. Clean the strainer.
f Reinsert the strainer. Screw the cold water connection pipe
onto the twin nipple.
f Open the shut-off valve in the cold water inlet line.
f Vent the appliance and the cold water inlet line (see chapter
"Commissioning / Initial start-up").
f Switch on the power supply.
15.2.2 Cleaning the strainer, installation on unfinished walls
f Isolate the appliance from the power supply.
f Close the shut-off valve in the cold water inlet line.
f Open all draw-off valves.
f Open the appliance by undoing the screw and lifting up the
appliance cover.
f Unscrew the cold water connection pipe from the twin nip-
ple. Pivot the cold water connection pipe upwards.
f Remove the strainer from the twin nipple. Clean the strainer.
f Screw the cold water connection pipe and the strainer with
sealed edge onto the twin nipple.
f Open the shut-off valve in the cold water inlet line.
f Vent the appliance and the cold water inlet line (see chapter
"Commissioning / Initial start-up").
f Check the cold water connection for leaks.
f Hook the appliance cover into the appliance back panel at the
top rear. Pivot the appliance cover downwards. Check that
the appliance cover is securely seated both top and bottom.
Secure the appliance cover with the screw.
f Switch on the power supply.
14 | DCE-S Plus
16. Specification

16.1 Dimensions and connections

217
140
175
b02
100
c06
b02 Entry for electrical cables I
c01 Cold water inlet
c06 DHW outlet
Alternative connection options
b03
b02
c06
b02 Entry for electrical cables I
b03 Entry for electrical cables II
c01 Cold water inlet
c06 DHW outlet
97
32
35
c01
109
DCE-S Plus
Finished walls
Male thread
Male thread
b02
30
b03
b02
15
b02
100
c01
DCE-S Plus
Finished walls
Unfinished walls
Male thread
Male thread
www.stiebel-eltron.com
G 1/2 A
G 1/2 A
G 1/2 A
G 1/2 A