Bresser 88-40000 Mode D'emploi page 17

G
Screw the locating screw for the vertical fi ne
adjustment (12) into the holder, in order to
fi rmly connect both parts.
H
Unscrew the nuts on the attachment screws
for the fi nderscope holder (4) on the telesco-
pe (1). Then put the holder with the fi ndersco-
pe (2) with the two holes over the attaching
screws and fi nally screw the nuts on again.
I
Now take the lens cap off the eyepiece (6).
You can now place the zenith mirror (15) into
the eyepiece holder and secure it with the
small screw on the connector.
j j
Next, you set the eyepiece (14) into the ope-
ning of the zenith mirror (15). Here too, there
is a screw with which you can screw the eye-
piece onto the zenith mirror.
Note: First, put the eyepiece with the largest
focal width (e.g. 20 mm.) onto the zenith
mirror. While you'll get the least amount of
magnifi cation, it will be easier for you to view
things.
GB
17