Bresser 88-40000 Mode D'emploi page 16

Your telescope consists of the
following parts:
1. Telescope (Telescope tube)
2. Finderscope with holder
3. Adjusting screws for the fi nderscope
4. Attaching screws and nuts for the holder
of the fi nderscope
5. Objective lens
6. Eyepiece holder (eyepiece connector)
7. Vertical fi ne adjustment knob
8. Telescope connecting piece
9. Tripod head with holder
10. Locking clips for the tripod legs
11. Tripod legs (extendable)
12. Locating screw for the vertical fi ne ad-
justment (upward and downward motion)
13. Locating screw for the vertical axis (for
turning to the right and left)
14. Eyepieces
15. Zenith mirror
16. Moon fi lter
16
You assemble the telescope as follows:
Before you get started with the assembly, you
should take some time to decide where you
would like to set up your telescope. It is im-
portant that you choose a place from which
you have an uninhibited view of the sky, whe-
re the fl oor is hard and even, and where you
have enough space around you so that you
can feel comfortable.
When you've found the ideal spot, you can
begin with the assembly.
d
First, open the locking clips on the tripod legs
(10). Then pull the lower parts of the tripod
legs (11) downward as far as they will go.
Finally, close the locking clips up again.
Tip: You can change the height of the tripod
at a later time by making the tripod legs a bit
shorter (again, opening the locking clips, ad-
justing the legs, closing the clips).
E
Now pull all three tripod legs out away from
each other, so that you can set the tripod on
the fl oor.
F
Connect the telescope (1) with the tripod by
pushing the telescope connecting piece (8)
into the holder on the tripod head (9).