Denver E Quick Rider X7 Mode D'emploi Et D'entretien page 13

• charging without memory effect
• big electric energy capacity, small volume, light in weight, with large current output, suitable for high
power vehicles.
• long life
• a wide working range of temperature: -10°C to +40°C
To ensure a longer battery life and protecting it from damage, please use and maintain it according to the
guideline below:
6.1 During your riding, when you find the power decreased to 20%
on the LCD. (See the Fig 6.1), the battery must be charged in short time!
6.2. Remember to charge the battery full before will ride for a long trip!
You can see the power station on display (Fig 6.0).
Or press the button on the top of battery case (Fig 6.2), when the
power is full, the four lights are all bright, when there is only one light
bright on the bottom, you need to charge immediately. There is a "F"
letter on the right of the top light, and "L" letter on the left of bottom light.
6.3 If the bike is ridden less frequently or stored for quite a long time, it
must be fully charged every 2-3 months.
Warning:
1) The battery life may be reduced after long storage without regular charging as instructed above,
due to natural discharge;
2) Never use any metals directly to connect the two poles of the battery, otherwise, the battery will
be damaged due to short circuit.
3) Never put the battery near to fire or heat source.
4) Never strongly shake, punch and toss the battery.
5) When the battery pack is removed from the bike, keep it out of reach of children, to avoid any
unexpected accident.
6) The battery is forbidden to be disassembled.
7. Using and maintaining the battery charger.
Before charging the battery, please read the owner's manual and the charger manual accompanied with
your bike, if any. Also, please note the following points regarding battery charger.
* Do not use this charger in an environment of explosive gas and corrosive substances.
Never shake, punch or toss the battery charger, to protect it from damage.
(Fig 6.1)
(Fig6.2)
13/54