Assembly Instruction - Denver E Quick Rider X7 Mode D'emploi Et D'entretien

1. Tyre & tubes
2. Rim
3. Spokes
4. Disc brake
5. Suspension fork
6. Front hub
7. Handlebar & stem
8. Brake lever
9. Grip shifter
10. Frame
11. Seat clamp
12. Seat post
13. Saddle

Assembly Instruction

THIS PRODUCT MUST BE ASSEMBLED BY A QUALIFIED TECHNICIAN AND SHOULD NOT BE ATTEMPTED
BY ANY ONE WHO IS NOT TRAINED
Ⅲ. MANUAL FOR THE ELECTRIC PARTS OF THE
The rider must pedal forward to obtain any assistance from the motor. This is an important safety feature.
This electric pedal assistance bikes will provide assistance up to 25 Km/h, after that the motor will cut out.
You may go faster but must do so under your own effort without the electric assistance.
To start the e-bike turn on the main switch on the side of the battery, the LCD on the handlebar panel will
light up. The motor will not work until you pedal a full revolution of the chain wheel. This feature protects
the motor and controller from damage and extends the service life of the electric components.
Contents
1. Structure of an electric assistance bike
2. Important safety cautions
3. Operation
4. Battery Installation & Usage.
5. LCD and function
6. Using and Maintaining the Battery
7. Using and Maintaining the Charger
8. Using and Maintaining the Motor.
9. Maintaining the Controller.
10. Maintaining the Power-off Control of the Brake Lever
14. Crank set
15. Pedal
16. Chain
17. Kickstand
18. Rear derailleur
19. Rear motor hub
20. Cable joint
21. Front derailleur
22. Display
23.Battery
24.Controller
25.Battery lock
E Quick Rider X7
5/54