Denver E Quick Rider X7 Mode D'emploi Et D'entretien page 11

2) CURRENT SHOW (see Fig.5.2):
It shows the current controller of the discharge current,
each grid shows for 2A, 6 grids show 12A or more.
(Fig5.2)
3) RIDING MODE SELECTION(Fig.5.3):
Three modes: POWER, NORMAL AND ECO. The arrow
Near the mode shows the selection. NORMAL is the
default setting.
POWER: under the assistance mode, the e-bike
max speed is top speed.
NORMAL: under the assistance mode, the e-bike
Max speed is 64% of top speed.
(Fig.5.3)
ECO: under the assistance mode, the e-bike
Max speed is 58% of top speed.
4) REAL-TIME SPEED:
Display shows the real-time riding speed, the
Kilometer and Mile can be selected by SET 4
(Fig 5.4)
5) 6KM/H:
Long press the key " - " 2 seconds then the 6KM/H function
start, the icon will be displayed on the screen.
(Fig 5.5)
6) PAS LEVEL SELECTION:
Press " + "or " - " to change the assistance level, 1 level is the
default setting. It means even though you don't pedal the bike
forward, the bike can start moving directly at max speed of
6KM/H only, provided this button is kept pressing. As soon as
this button is released, the bike will stop immediately.
(Fig 5.6)
7) ERROR CODE INDICATOR:
When the system fails, the error icon and
error code will flicker at the frequency of 1Hz.
Different fault codes represent different fault
Information.
(Fig 5.7)
11/54