Orientation Of Unit; Installation Of Diffuser Filters On The Arcaline2 3G; Connections - Ayrton arcaline2 3G Mode D'emploi

Orientation of the unit
The floor stands can be installed in two different ways.
It is therefore possible to obtain two types of directional
settings on the unit, as shown in the following diagrams :
Installation of the diffuser filters on the
ARCALINE2 3G
The ARCALINE2 3G can be fitted with specially-designed
diffuser filters, enable the angle of the unit's beam to be
adjusted, depending on the application for which it is
intended.
WARNING !
Only use original ayrton filters in the ARCALINE2 3G.
The ARCALINE2 3G has an internal filter holder to house the
diffuser filters.
These specially-designed diffuser filters are manufactured by
AYRTON and are available in several versions, depending on
the diffusion Angle required.
They come in the form of a kit with two 2 translucent plates,
each covering half of the projector's LED groups.
In order to install the filters, each plate must be inserted into
the unit on one end, and both sides of the projector must
therefore be opened.
Details of the filters installation :
of a 2.5 mm hex key
head screwdriver
filter housing, as well as its waterproof seal (number 5)
each side. From then on take care to hold the filter by the
edges and avoid touching the sides
purpose (see diagram below), making sure the granular
side of the filter faces the glass on the unit
filter housing and its waterproof seal (number 5), then
screw the parts in place by tightening the two Philips head
screws (number 3)
by tightening both HEX screws (number 1)
other side of the unit

Connections

The ARCALINE2 3G is equipped with two cables fitted with
hybrid connectors (1 cable is located at either end of the
projector).
The cable fitted with a male connector is the unit's input cable.
The cable fitted with a female connector is the unit's output
USER MANUAL 9
Unscrew the two HEX screws (number 1) with the help
Remove the removable casing (number 2)
Unscrew the two screws (number 3) using a Philips
Remove the plate (number 4) covering access to the
Take a filter and remove the protective films stuck to
Insert the filter fully into the housing provided for this
Replace the plate (number 4) covering access to the
Place the removable casing (mark 2) and fix to the unit
Repeat this procedure to install the second filter on the