Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Description
1 - Body of the unit
2 - Glass
3 - Lateral flank input side
4 - Lateral flank output side
5 - Input cable
6 - Output cable
7 - LED matrix no. 1 (input cable side)
8 - LED matrix no. 2 (output cable side)
3 - Lateral flank input side
9 - Removable casing covering the lateral flank
10 - Clamping screw for the bracket
11 - Support screw for the removable end shield (2 screws)
12 - Bracket
13 - Removable floor stand
14 - Floor stand screw (size M10, head "H")
16 - Device Label
17 - Window specifying the model reference and the unit
serial number
18 - Window specifying the Identifier Number (ID) of the unit
Installation
Assembling the floor stands
The ARCALINE2 3G projector is supplied with two
unassembled stands, which enable the projector to be
placed on a flat support and, where necessary, to fix it to said
support using screws (not supplied).
These stands are to be fixed to the unit's adjustable brackets,
using the screws and nuts supplied, as shown in the following
assembly diagram :
1 - M10 screw with hexagonal head
2 - Stand
3 - M10 Locknut
Note :
A 17-mm open-ended spanner is required for this operation
(not supplied)
The stands may be installed on the unit in two different ways,
in order to allow different directional settings for the projector
(see below in this manual)
Fixing the clamps on the
ARCALINE2 3G
In the event that the unit is to be fixed to a tubular structure,
the stands supplied with the ARCALINE2 3G can be replaced
with tube clamps and fixed to the unit by corresponding
screws/nuts (clamps and hardware not included). The centre-
to-centre distance on the tube clamps will be 962 mm.
The following illustration shows an ARCALINE2 3G fitted with
tube clamps :
8
USER MANUAL
Publicité
Table des Matières
