Attaching The Grass Collector To The Mower (Illustration R1 + S1 ); Adjusting The Cutting Height (Illustration I ); Before Using The Lawnmower For The First Time; Filling With Oil (Illustration Y1 ) - Sabo 47-K VARIO B Livret D'entretien

Attaching the grass collector to the mower (Illustration R1 + S1 )

– Insert the collection bag frame with the bar first into the grass catch. Align the upper seams of the grass catch on the bar.
– Press the holding profile onto the frame of the collection bag frame R1 .
– Open the ejection flap of the mower upwards.
– Lift the grass collection bag on the carrier bar, insert the chute (1) R1 on the collection bag opening into the ejection
flap and hang the grass collection bag with the two side hooks to the top of the mower housing S1 .
– Fold the ejection flap onto the grass collection bag.

Adjusting the cutting height (Illustration I )

You can set the desired cutting height with the adjustment lever (1) on the left of the mower.
– Pull the lever out of the catch and latch again after a lateral move into the desired position.
– The marking on the left of the housing indicates the cutting height.
IMPORTANT
Mowing at the lowest cutting height should only be carried out on level and plane lawns!
Please note that the lower cutting height settings may only be used for optimum conditions. If you select cutting
height that is too low, the turf may be damaged and under certain circumstances even destroyed.
Besides the cutting height, the driving speed also influences the cutting pattern and collection result. Adapt the
cutting height and driving speed to the grass height to be cut, the motor drive may not need to be switched on.

8 BEFORE USING THE LAWNMOWER FOR THE FIRST TIME

Check that all connections and the spark plug connector are fitted firmly. Tighten the screws if necessary! In particular make
sure that the cutter bar is fitted correctly (see Chapter "Maintenance of the blade").
The blade attachment screw should always be fitted and tightened by a specialist workshop. If the blade attachment screw is
too tight or too loose, the blade clutch and blade can be damaged or become detached, which can cause severe injury.
Make sure that all safety devices are fitted properly and are not damaged.

Filling with oil (Illustration Y1 )

IMPORTANT
Avoid damage! Engine is delivered without oil. You must add oil before running the engine.
Before starting the mower the first time fill motor oil (for quantity and type, see technical data) into this opening with a funnel
after unscrewing the dipstick.
– Park mower on a level surface.
– Pour in oil slowly into the oil filler. Do not pour in too much oil.
– Check the oil level.
Remove the dipstick. Wipe the dipstick with a clean cloth, insert the dipstick into oil filler without screwing it in Then
remove the dipstick once again and read off the oil level. The oil must be between the marks "ADD" and "FULL". Add oil
if necessary. However the oil level should not be above "FULL" mark. Replace oil dipstick and retighten.
– After filling up for the first time remove the "NO OIL" sign on top of the engine.

Filling with fuel

– Only fill the tank with fresh and clean unleaded standard petrol. Fuel with up to 10% ethanol is acceptable.
– The petrol tap should be kept closed Y2 !
– Unscrew tank cap.
– Fill tank with fuel using a funnel up to max. lower edge of filling nozzle.
– Replace tank cap and screw tight.
See table for explanation of symbols page 3
See table for explanation of symbols page 3
See table for explanation of symbols page 3
See table for explanation of symbols page 3
9
Safety instruction!
Safety instruction!
GB
Safety instruction!
Safety instruction!