Level Gauge; Filling With Engine Oil And Checking The Oil Level; Filling With Petrol - Grizzly Tools BRM 42-125/2 BS Traduction De La Notice D'utilisation Originale

GB
Dismantling/Empty out the
Grass Collection Box:
9. Lift the impact protection (21)
and remove the grass collection
box (19).
10. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.

Level gauge

The level gauge (
the side of the grass catcher (
aerodynamic air guidance provided by the
flap also optimises the filling.
GO Flap open: grass catcher empty
STOP Flap closed: grass catcher full
Filling with Engine Oil and
Checking the Oil Level
Place the equipment on a level
base.
1. Unscrew the oil filler cap and dipstick
(16) and pour oil into the tank. Use
brand oil (e.g. HD SAE 30 or 10W-30).
2. To check the oil level, wipe the dipstick
(16) on a clean cloth and replace it in
the tank until it stops.
3. After pulling it out, read off the oil
level on the dipstick. The oil level
should be in the marked area be-
tween the minimum and maxi-
mum marks.
4. Wipe off any spilt oil and close
the oil filler cap (16).
Check the oil level every time be-
fore mowing and add oil before the
lower marking point is reached.
86
23) is located on
19). The

Filling with Petrol

Warning! Petrol is flammable and haz-
ardous to health:
- Keep petrol in containers intended for
this purpose;
- Only refuel outdoors and never with
the engine running or when the ma-
chine is hot;
- Open the filler cap carefully to allow
excess pressure to escape;
- Do not smoke whilst refuelling;
- Avoid skin contact and inhalation of
the fumes;
- Remove spilt petrol;
- Keep petrol away from sparks, open
flames and other ignition sources;
- Dispose of leftover petrol in an envi-
ronmentally friendly way (see "Dis-
posal / Environmental Protection").
- Do not use petrol/oil mixtures;
- Use normal or super unleaded
petrol;
- Only use clean, fresh petrol;
- Do not store petrol for longer
than one month, as its quality
deteriorates.
1. Unscrew the filler cap (
and pour in the petrol to the filler
plugs (32). Do not fill the tank
entirely, to allow the petrol room
to expand.
2. Wipe away petrol residues
around the filler cap and close
the filler cap.
7)