Zeiss Primo Star Mode D'emploi page 38

Carl Zeiss
Fig. 34 Reflected-light LED module
• Attach the holder (Fig. 34/2) again, tighten the screws (Fig. 34/1) only slightly, still allowing
displacement of the LED module within the guide.
• Shift the LED module frontward (operator side) against the stop and fix the screws (Fig. 33/1)
handtight. This step is important to re-establish the optimally adjusted optical configuration.
• Plug the connector (Fig. 34/3) again into the circuit board.
• Put on the lid and tighten the three fastening screws (Fig. 33/1) after shifting the lid in direction of
arrow to the front right corner (Fig. 33) to realign the correct optical axis.
• Attach the tube again (see also section 3.5.1).
38
Care and Troubleshooting Primo Star / Primo Star iLED
M60-2-0011 v 08/2008