Zeiss Primo Star Mode D'emploi page 17

Primo Star / Primo Star iLED
• Loosen the set screw (Fig. 9/6) on the back of
the device, unplug the connector (Fig. 9/2) of
the plug-in power unit (Fig. 9/5) and insert it
into the connection socket (Fig. 9/1) of the
reflected-light illuminator.
• Plug the connector (Fig. 9/3) of the reflected-
light illuminator into the connection socket
(Fig. 9/4) at the stand and tighten the set screw
(Fig. 9/6).
• Fasten
the cable
illuminator by pushing it into the cable clip
(Fig. 9/7).
• Insert the plug-in power unit into a power
outlet.
Mounting the slider with yellow filter to the
luminous-field diaphragm
• Unscrew the cover cap (Fig. 11/2) from the
luminous-field diaphragm (Fig. 11/3).
• Turn the slider (Fig. 10/3) upside down. Loosen
the clamping screw (Fig. 10/4) of the supporting
ring and remove the supporting ring (Fig. 10/1)
upward.
• Put the cover cap (Fig. 10/2), with its upper side
facing downward, into the slider (Fig. 10/3).
• Insert the supporting ring (Fig. 10/1) into the
slider and fix it with the clamping screw
(Fig. 10/4).
M60-2-0011 v 08/2008
Start-Up and Operation
of the reflected-light
Fig. 9 Connecting the power supply unit
Fig. 10 Inserting the cover cap into the
slider
Carl Zeiss
17