Maintenance; Technical Support - Dimplex XHD28L Manuel D'utilisation

Maintenance

Resetting the Temperature
Cutout Switch
Should the heater overheat, an
automatic cutout will turn the heater off.
It will not come back on without being
reset.
To reset the cutout switch, unplug the
unit and wait 5 minutes before plugging
it back in.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Technical
Support at 1-888-346-7539
General
Inspect the electric firebox regularly,
depending upon conditions, and at a
minimum yearly intervals. Remove dust
and clean with damp cloth as required.
CAUTION: Except for installation and
cleaning described in this manual,
an authorized service representative
should perform any other servicing.
WARNING: Disconnect power by
unplugging the power power and allow
heater to cool before attempting any
maintenance or cleaning to reduce the
risk of fire, electric shock, or injury.
14
Battery Replacement
To replace the battery:
1. Remove the screw on the battery
cover using a Philips screwdriver.
2. Depress tab and pull out to release
battery compartment on bottom of
the remote control.
3. Correctly install one 3 Volt
(CR2032 [longer life] or CR2025)
battery in the battery compartment
4. Insert the battery compartment and
secure with the screw.
Battery must be recycled or
disposed of properly. Check with
your Local Authority or Retailer for
recycling advice in your area.

Technical Support

Support Services
Technical and troubleshooting support,
as well as a list of replacement parts
can be found on:
www.dimplex.com/support
www.dimplex.com