Dimplex XHD28L Manuel D'utilisation page 11

Operation
Icon Function
A
Power
B
Heat
C
Temperature
Disable Heat
Description
Press to turn the unit on or put it in Standby mode.
When the unit is turned back on, it will retain the
previously used settings (except timer).
• Heat On
Press to turn heat on (indicated by 1 short
beep). Display will show current heater
temperature setting and, after 2 seconds, the
room temperature. Use the Temperature icon to
change the heater temperature setting.
NOTE: When the heater is switched on, the
heater fan will operate. The heater element may
or may not be on depending on the thermostat
setting (see "Temperature" section).
• Heat Off
Press to turn heat off (indicated by 1 short beep).
NOTE: After the heater is switched off, the fan
will continue on for 2 minutes before turning off.
Press multiple times to cycle through the 13
temperature settings:
72°F, 74°F, 76°F, 78°F, 80°F, 82°F, 84°F, On (
18°C, 19°C, 20°C, 21°C, 22°C, 23°C, 24°C, 25°C,
26°C, 27°C, 28°C, On [continuous operation]).
NOTE: To operate the fan without heat, turn the
heat on and select a temperature setting that is
below the room temperature.
Press once to display the set temperature. It will
flash for 3 seconds and then display the room
temperature.
On the touch panel, press the Heat and Temp
buttons at the same time and hold for 2 seconds
to disable the heater. Press and hold again for
2 seconds to enable the heater.
When the heater is disabled, "--" will display when
Temp button is pressed. The remainder of the
unit's controls will operate in the same fashion.
64°F, 66°F, 68°F, 70°F,
62°F,
17°C,
11