Batteries; Maintenance - Dimplex Gala Manuel D'installation

L

2.5 Batteries

2.5.1 Replacing the batteries.
1. Remove the lid of the batteries compartment at the back of the remote control. (see Fig. 8).
2. Place the batteries.
3. Put the lid of the batteries compartment back in its place.
The batteries should be discharged properly in accordance with local requirements.

2.6 Maintenance

WARNING: Always remove the plug from the wall socket before performing maintenance.
2.6.1 Replacing lights
If a large quantity of smoke is grey or colourless it is possible that one or more lights is not burning.
You can check this as follows.
1. Pull the drawer while the flame effect is active. (See Fig. 3).
2. Look at the lights from a distance to see which light(s) are broken.
3. Put switch "A" in the "OFF" position, and remove the plug from the wall socket.
4. Leave the appliance like this during 20 minutes so that the lights can cool down before
removing them.
5. Remove the water tank by lifting it up and to the front and put it in a sink.
6. Remove the collection reservoir as described in chapter 2.8.2 .
7. Remove the broken light(s) by pulling it from its holder. (see Figs. 5 and 6). Replace the
light by a Dimplex Opti -opti-myst, 12V, 50W, basis Gu 5.3, 8º radiation angle, coloured
light. (obtainable from your dealer).
8. Gently push the light(s) with the 2 pins in the corresponding holes (See Figs. 5 and 6).
9. Put the collection reservoir and the water tank back in their positions.
10. Put the plug in the wall socket and put switch "A" in the "ON" position.
2.6.2 Filling the water tank.
When you use the appliance for the first time or when you hear two beeps and the lights have gone
out the water tank needs refilling.
Proceed as follows.
1. Open the drawer.
2. Put switch "A" in the "OFF"(0) position. (see Fig. 2).
3. Remove the water tank by lifting it up.
4. Put the water tank in the sink and open the cap. (See Fig. 7).
Fill the water tank with water with a hardness as indicated in chapter 2.2.
5.
20 < < < <