Section 3 Safety; Section 4 Instrument Setup And Storage - TSI ALNOR LOFLO BALOMETER Manuel Du Propriétaire

When using the LoFlo Balometer
to check air flow at ceiling diffusers, make certain
that you can safely raise and hold the unit while
making measurements. Be especially careful
when working on a ladder.
Observe all necessary precautions so that the unit
does not become caught in moving machinery or
touch any exposed electrical wiring.
W
HILE USING THE
MAY COME INTO CONTACT WITH OR BE EXPOSED TO DUST
OTHER AIRBORNE CONTAMINANTS
MOLD
MASK OR RESPIRATOR WHILE EMPLOYING THE
Hood Setup
1. Locate the four (4) aluminum channels for the
hood and position them into a square with the
foam facing up. Slide the "U" opening on the
channel end (Fig. 1) and corner bracket
toward the brass eyelets until you feel it latch.
2. Continue with the other two channels until you
have a square frame that is locked tightly in all
four corners.
3. Locate the hood for the frame size you have
assembled.
4. Position a corner seam of the hood onto the
corner of the frame. Stretch the nylon hood to
an adjacent corner until the hood corner
meets the frame corner.
5. Push the elastic cord into the channel along
the side of the frame.
6. Repeat steps 4 and 5 until the hood assembly
is complete and ready to mount onto the base.
7. Place hood on a table or clean floor with the
base inside the opening. Pull the hood over
2
SECTION 3
®
Capture Hood
L F B
O LO ALOMETER
, ,
FUNGUS OR OTHER AIRBORNE CONTAMINANTS
SECTION 4
Instrument Setup and Storage
Safety
The LoFlo Balometer
designed for gas mixtures other than air. Use with
corrosive or other dangerous or explosive gas
mixtures is not recommended and is at the user's
risk.
C A U T I O N
®
INSTRUMENT TO TEST AIR FLOW IN DUCTS
,
. I
F YOU ARE OR MAY BE SENSITIVE TO DUST
,
ALWAYS USE AN APPROPRIATE
L F B
O LO ALOMETER
the base. Rotate the hood assembly until the
metal cups are above the spring-loaded pins.
8. Locate the hood support rods. Extend the
hood so it is taut and insert one support rod
onto the spring-loaded pin closest to you.
9. Push the support rod down and insert the top
end of the rod into the metal cup on the hood
frame. Fig 1.
10. Install the rod on the opposite side then install
the last two rods.
®
Capture Hood is not
,
, ,
POLLEN MOLD FUNGUS
,
POLLEN
®
.
INSTRUMENT
Figure 1
Hood Frame Channel
YOU
,
OR
,