Operation - Meister MAS18V Traduction Du Manuel D'utilisation Original

Charging the battery pack
(Figure 3)
CAUTION! The rechargeable
battery is not completely
charged when it leaves the facto­
ry. Charge the battery pack before
using for the first time.
CAUTION! Only use the sup­
plied charger to charge the
rechargeable battery (12).
CAUTION! Check the voltage
specifications of the charger
(12) with the voltage of your mains
power supply before plugging the
charger in.
1. Plug the charger (12) into the
socket. The charging status check
light (13) on the charger lights up
in green and signals when ready
to operate.
2. Slide the rechargeable battery
through the charging cradle (14)
over the contacts of the charg-
er (12) until it clicks audibly into
place. During the charging pro-
cess, the charging status check
light (13) on the charger turns to
red.
3. The charging process should take
about 60 minutes. It is finished as
soon as the red LED goes out and
the green LED lights up.
4. Press the unlocking button (8)
on the rechargeable battery and
remove the rechargeable battery
from the charger.
72
MW-5451280-Bedien-2008.indd 72 MW-5451280-Bedien-2008.indd 72
CAUTION! The rechargeable
battery is to be removed from
the charger after the charging
time is complete. A constant
warming of the charger and the
battery is normal and is not a
fault.
Battery pack charge monitoring
(Figure 4)
To monitor the charge state, the
battery capacity status display (4)
lights up during operation.
The charge state is shown as fol-
lows:
• Green/Yellow/Red:
The rechargeable battery is fully
charged.
• Yellow/Red:
The rechargeable battery is par-
tially discharged.
• Red:
The rechargeable battery must be
charged.
9 – Operation
Torque pre­selection
The cordless drill/screwdriver has
a torque setting function with 25+1
levels which helps to avoid damage
to the screw or drill head. By rotating
the torque setting (2) on your cordless
drill/screwdriver, you can select the
required level, from 1 (easy screw-
driver action) through to maximum
(heavy-duty screwdriver/ drilling
26.08.20 09:07 26.08.20 09:07