Operation And Mode Of Working; Maintenance And Environmental Protection - Meister i-drill MAS36ip3 Traduction Du Manuel D'utilisation Original

5450210-Akku-Schra_man 11.03.16 08:41 Seite 46
8 – Operation and mode of
working
Placing the tools (Fig. 3)
Insert the bit adapter (b) into the bit
holder (4) as far as it will go. Select a
suitable bit (a) and insert it into the bit
adapter.
Screwdriver and drill bits with a length
upwards of 50 mm can also be inserted
directly into the bit holder.
Select direction of rotation,
clockwise/counterclockwise
Inserting screws: Set switch for
clock wise or counterclockwise
rotation (2) to "Clockwise" as
shown in Fig. 1.
Loosening screws: Set switch for
clock wise or counterclockwise
rotation (2) to "Counterclockwise"
as shown in Fig. 1.
The LED charging and rotational
direction (5) shows, during operation,
and according to the position of the
right/left switch (2), the rotational
direction that has been selected by
means of the orange light on the relevant
arrow display:
Right = ▲, Left = ▼
Prior to start up
Fit a suitable bit or socket to the battery-
powered screwdriver and place firmly
against the screw.
46
Starting and stopping
Caution! Risk of over winding
caused by screwing screws in too
deep. Watch the screwing process
carefully and, if necessary, stop early
and finish the process with an ordinary
screwdriver. Always practise first!
• Starting:
Press the ON/OFF switch (1): The
screwing process will start. Press and
keep the switch during the screwing
process.
• Stopping:
As soon as the screw has been screwed
in or removed fully, release the On/Off
switch. The process is completed and
the working light will go out.
Switching on the LED working light
When the unit is switched on,
the LED working light (3) also
comes on to ensure better vision
and to make working in dark areas more
safe. The working light goes out when
the On/Off switch is released..
CAUTION! Do not look directly
into the working light and the
LEDs of the cordless charging display
since this may result in damage to the
eyes.
9 – Maintenance and
environmental protection
Clean the case only with a damp cloth –
Do not use solvents. Then dry well. The
place of storage must be dry; the ambient