Operation - Meister AS18VM Traduction Du Manuel D'utilisation Original

5401520-Akkuschrau_man 04.12.14 10:58 Seite 47
The normal charging time is around
3-5 hours. After this, the charger
ensures constant maintenance of the
charge. The battery is protected from
overloading by a thermal protection
mechanism, thus it can be left in the
charger for long periods of time without
damaging the battery.
An even warming of the charger and
battery is normal and does not
represent a fault. A battery with a
considerably shortened operating time
indicates that it needs to be replaced.
Note: The range of the battery is
influenced by the charged state, the
frequency of use, the material being
processed and the level of energy
required to do so.
A new battery only reaches full
performance capability after 5 charge
and discharge cycles.
It the range of a freshly charged battery
should drop considerably when
compared to a new one, the battery is
old and should soon be replaced by a
new one.
To do this, contact the specified service
station.
The rechargeable battery is protected by
a thermo-protection fuse against
overcharging - nevertheless it should be
withdrawn from the charging unit on
expiry of the charging time.
A constant heating of charging unit and
rechargeable battery during the charging
is normal and does not represent any
malfunction.
All manuals and user guides at all-guides.com
charging process via an electrical
time-switch clock!
8 – Operation
All standard screwdriver bits, bit
holders and drills, up to a diameter of
10 mm (not in the scope of delivery),
can be clamped in the drill chuck (5)
(Fig. 4).
The machine is provided with a quick-
action drill chuck. In this way, you can
replace the accessories in manual
operation rapidly and without drill chuck
keys (Fig. 5).
always fixed with a left-hand thread
bolt. This is to be loosened in front
through the drill chuck (5) before a drill
chuck change. Left-hand thread bolts
can be loosened through clockwise
rotation only.
The screwdriver bits and drill bits with a
length of 50 mm can also be inserted
directly into the bit receptacle.
Prior to start up
Insert a wood screw gently into the hole
pre-drilled using a drill bit. Machine
screws should be started off gently. Fit a
suitable bit or socket to the battery-
powered screwdriver and place firmly
against the screw.
TIP! It is recommended
additionally to control the
The drill chuck of clockwise/ anti-
clockwise rotation machines is
47