Troubleshooting And Assistance; Replacement Parts List; Service Instructions - Meister MAS18V Traduction Du Manuel D'utilisation Original

15 – Troubleshooting and assistance
Faults
No functionality.
On/Off switch
cannot be pressed.
Machine does not start up.
Drill does not cut/hardly cuts
into the material to be drilled.
In the event of any other faults and errors, consult the customer service
department detailed in the guarantee documentation.
16 – Replacement parts list
The following parts may be pur-
chased by ordering from the cus-
tomer service department. They are
also available from your specialist
dealer.
Battery pack: MAS18VAP
Art.-Nr.: WU5451290
17 – Service instructions
• Store the machine, operating
instructions and where neces-
sary the accessories in the origi-
nal packaging. In this way you will
always have all the information
and parts ready to hand.
• Meister devices are to a large
extent maintenancefree, a damp
cloth being sufficient to clean the
MW-5451280-Bedien-2008.indd 77 MW-5451280-Bedien-2008.indd 77
Potential causes and remedies
– Rechargeable battery charged?
– Rotation direction switch set to cen-
tre position?
(Machine cannot be switched on).
- The rotation direction switch
is in the centre position
– It is possible that the carbon
brushes are worn.
Consult a specialist workshop.
– Hammer drilling required?
– Correct drill bit selected?
– Is the machine accidentally set to
left rotation?
casing. Do not drop electrical
machines in water. Please note
additional hints given in the oper-
ating instructions.
• Meister devices are subject to
stringent quality control. If howev-
er a functional fault shoult occur,
send the device to our servicing
address. The repairs will be car-
ried out in a short time.
• A brief description of the defect
speeds up the faulttracing and
repair time. If within the guarantee
period, please enclose the guar-
antee document and the proof of
purchase.
• In so far as a repair under guar-
antee is not concerned, we will
charge the repair costs to your
account.
77
26.08.20 09:07 26.08.20 09:07