Unpacking And Checking; Charging The Rechargeable Battery - Meister MAS18V Traduction Du Manuel D'utilisation Original

CAUTION! The vibration emis­
sion value may fluctuate from
the specified value during use of
the power tool. These fluctuations
will depend on the way in which
the power tool is used.
Try to keep the vibration loads
as low as possible. Examples of
measures that may be taken to
reduce the vibration load include
wearing gloves when using the
tool and limiting the length of the
working period. All parts of the
operating cycle must be taken
into account for this purpose
(for example, by also including
times in which the power tool is
switched off and times in which
it is switched on, but is running
without load).
CAUTION! A certain amount
of noise is unavoidable when
using this device. Ensure you
carry out noise­intensive work
during permitted times. Maintain
the quiet periods and limit your
work to the absolute minimum.
CAUTION! The effects of
noise may cause damage to
the hearing. Only ever work with
suitable ear defenders. Anybody
else in the vicinity should thus
also wear ear defenders.
7 – Unpacking and checking
1. Remove the packaging materials
and all protective foils.
MW-5451280-Bedien-2008.indd 71 MW-5451280-Bedien-2008.indd 71
2. Pay attention to ensure that the
packaging material and foils do
not enter the hands of children.
Risk of suffocation!
3. Check the machine and accesso-
ries for completeness and for any
visible damages. In the event of
any kind of damage, do not start
to use the machine.
8 – Charging the rechargea­
ble battery
CAUTION! The rechargeable
battery of type MAS18VAP
belonging to this cordless drill/
screwdriver MAS18V may only be
charged using the charger type
XZ2200­2400K. Any use of any other
charger or the use of charger type
XZ2200­2400K connected to a
power supply other than the one
listed on the type plate may lead to
personal injury and damages.
Removing the rechargeable bat­
tery (Figure 2)
Press the battery unlock button (8)
and pull the battery pack (7) out
battery holder (9).
Inserting the battery pack
(Figure 2)
Slide the rechargeable battery (7) as
far as it will go into the battery hold-
er (9) and allow it to click into place.
71
26.08.20 09:07 26.08.20 09:07