How To Use; After Use - Meister MAS18V Traduction Du Manuel D'utilisation Original

beam of light as this may result in
damage to the eyes.
10 – How to use
Electronic revolution regulation
The electronic revolution regulation
can be achieved by adapting the
revolutions steplessly to the process
you are using.
• A light pressure on the On/Off
switch (10) = Low revolutions to
undo stubborn screws.
• Push down fully on the switch =
Highest revolutions to drill with.
CAUTION! When drilling or
using as a screwdriver, avoid
the motor coming to a standstill
under load!
Direction of rotation, right/left
(Figure 6)
The direction of rotation is deter-
mined using the "Right/Left" switch
(5) above the power switch.
CAUTION! The direction of
rotation may only be changed
when the motor is at a standstill!
• Installing screws: Set the right/left
switch (5) to right rotation.
• Removing screws: Set the right/
left switch (5) to left rotation.
• Safety position: Centre switch
74
position; with the sliding switch in
MW-5451280-Bedien-2008.indd 74 MW-5451280-Bedien-2008.indd 74
this position, the machine cannot
be operated. Use, for example,
when taking a break or changing
bits or drills.
CAUTION! Risk of over wind­
ing caused by screwing
screws in too deep. Watch the
screwing process carefully and, if
necessary, stop early and finish
the process with an ordinary
screwdriver. Carry out test instal­
lations!
Gear switch (Figure 8)
Using the gear switch (3) you may
select two different revolution rang-
es.
• Switch position 1:
-1
0 – 400min for installing and
removing screws
• Switch position 2:
0 – 1500min -1 for installing screws
and drilling
The revolution range to be select-
ed is determined by the relevant
material and the intended task and
should be tested using a test piece.
CAUTION! Only switch over
when the motor is at a stand­
still.
11 – After use
• Release the On/Off switch to
switch the machine off.
26.08.20 09:07 26.08.20 09:07